The following preparation is our minimum standard.
- Solvent clean to remove dirt and grese
- Lightly sand welds and grind marks
- Drill 4m hole for hanging (extra cost)
*** ALL HOT DIP GALVANIZED products require de gas in oven prior to the final top coat.
Cusomers must be aware that Hot Dip Galv will always show lumps bumps and small bubbles, even after our regular preparation and powder application. This is a normal procedure of the product and can’t be avoided.
*** ALL ALUMINIUM products (excluding anodized) require pre-treatment prior to powder coating.
A. Acid bath of Chemetall meatl-etch
B. Fresh water rise
C. Chromate bath of Chemetall chromacoat
D. Fresh water rinse
All steel products in close proximity to river, ocean or near pool, manufacturers recommend E/Prime prior the final coat to maximise longevity.
Previously powder coated products can be repowder coated to a different colour but will never be the same finish as 1st coat. Some blemishes (especially when powder coating lighter colour on top of daeker colour) will be visible and we offer no warranties aginst this.
Once powder coated product is reworked, i .e. screwed, drilled or cut, these areas are targets for corrosion and must be sealed appropriately from moisture immediately.
FAQs
What is powder coating?
Powder coating is a type of protective and decorative coating that is applied to metals (such as aluminium and steel), electrostatically as a dry powder and then cured in an oven. The curing process heats the dry powder allowing it to flow and form a tough solid film. Powder application does not require a solvent and is VOC free making it a less hazardous coating with environmental advantages.
To get the very best result, powder coating has to be done on a clean surface. The paint has to be totally stripped off by either sandblasting, soda blasting or with chemicals prior to powder coating.
Can you powder coat over powder coat?
Yes, we can recoat but there are no guarantees on the finished product.
How much will it cost?
Our pricing structure is based on volume, technology and the choice of colour used. We are able to give you an approximate price over the phone. Once we see the product on site, we will be able to give an exact price.
How long will it take?
Popular colours are run weekly. We endeavour to meet your deadlines. A 24 hour turnaround is available at an additional cost.
What is your oven size?
Up to 4.5 mtrs L x 1.2mtrs w x 2.0 mtrs h
Do you sandblast on site?
No. We use reputable sandblasters locally.
Do you have touch up paint?
Yes we carry an extensive range of touch up paint, cold Gal primers, Etch primers and Plastic primers